Lathe 32 Tailstock jpg
406px x 565px | 23.20kB

[source page]

Lathe 32 Headstock jpg
404px x 596px | 21.30kB

[source page]

lathe jpg
600px x 600px | 59.10kB

[source page]

metal lathe jpg
498px x 480px | 170.30kB

[source page]

Return to Tour Return to Tour

Drilling jpg
352px x 600px | 38.50kB

[source page]

not the drill These factors combine to provide a beautifully centered starting hole This is much much easier than trying to center a rod on a milling machine On a lathe drilling the smaller hole for the motor shaft and the larger hole for the Lego cross axle Replace the center drill with a smaller diameter drill that matches the

185210d12460385​87 metal lathe lathe small jpg
426px x 640px | 45.50kB

[source page]

Attached Thumbnails

le8679 jpg
448px x 348px | 37.80kB

[source page]

LE8679 Used Stanley Gap Bed Lathe

IMG 1944 jpg
480px x 640px | 76.60kB

[source page]

Motor Tools 1 jpg
390px x 520px | 25.50kB

[source page]

While building the 383 SBC I made a few tools to help These were made when I decided to degree the cam just so I knew what that was all about I had a nut that went on the front of the

Motor Tools 7 jpg
420px x 472px | 34.60kB

[source page]

is so I can move the bolt over there if I want For instance the piston in the picture is dished I can locate either off of the dish or the flat area to the left of it Here is everything in place I degreed the cam and it was right on the specs so I did all of this for nothing but I m glad I made the tools and learned how to degree the cam in

Har Bal Rotater 5 jpg
385px x 446px | 28.90kB

[source page]

the three holes and had to elongate them some for alignment This is a non critical piece safety wise so I just made the change instead of starting over Next I grabbed the piece by the outside and turned the inside out

182065d12437147​82 metal lathe lathe2 jpg
267px x 666px | 26.70kB

[source page]

lathe2 jpg 26 7 KB 94 views

lathe bor bar holder 1 jpg
378px x 504px | 23.20kB

[source page]

I have the boring bar set shown above that is used with a boring head for my mill I wanted to be able to also use these in the 4 way post on my lathe so I made a simple holder for them

IMG 0249 jpg
768px x 1024px | 232.30kB

[source page]

IMG 0260 jpg
768px x 1024px | 240.40kB

[source page]

hemisphere

IMG 0339 JPG
480px x 640px | 57.20kB

[source page]

side view JPG
768px x 1024px | 432.60kB

[source page]

metal spinning machinery
600px x 400px | 43.70kB

[source page]

186178d12467169​99 metal lathe img 3799 small small jpg
480px x 640px | 57.30kB

[source page]

Attached Thumbnails

lathecarriageca​stbad JPG
480px x 640px | 105.20kB

[source page]